The previous week. I'm looking for information on the MIG 100 Flux Wire Welder, so i would like to describe here.
I bought this as my first welder just to do chores around the House. It ended really exceeding my expectations, and I found that I can make pretty damn good looking welds with this unit. I have welded up to 1/4 "steel with it and the penetration is pretty good with that thick but I personally have not done anything thicker and cannot guarantee that this welder would penetrate much deeper than 1/4". I used the hell out of this welder and is still holding
90 Amp Flux wire, 120Volt / 60Hz, ETL approved. No Load Voltage: 31 Volt, adjustment positions: 2 steps. Range of current 50 to 80 Amp. Duty cycle: 15% at 80A, 20% at 65A. Rated duty cycle: 10% at 90amps. Insulation Class: F, welding wire size is 035 to 040 inches. Includes: Welding torch, tip, grounding cord with clamp Brush / hammer, Face shield, Flux cored wire .030 inch (2 .... Read more or Check Price
0 comments:
Post a Comment